Anand Sheel Hydraulics

Home		Here You are -	Filters !


				HYDRAULIC PRODUCTS
	Hydraulic and Lubrication Filters
• >>	Filter from INTERNORMEN-Filter can be used for mineral oils, emulsions and for most synthetic Hydraulic fluids and lubrication oils.


• >>	Tank Mounted Return-Line Filters	• >>	Return-Line filter


• >>	Pressure Filters	• >>	Pressure Filters, change - over


• >>	Pressure Filters	• >>	Pressure Filters PN > 100


• >>	Pressure Filters, flangeable PN > 100	• >>	Stainless Steel Filters - Offline Filters


• >>	Tank mounted suction filter	• >>	Tank Breather


• >>	Spin On Filters	• >>	Offline Filter unit - Oil service equipment


	Filter Media: INTERNORMEN-FILTER = High Quality Standard. The filter material used in the elements is supported by combining a special fibre material and stainless steel wire, which stops damage to the fibre during production and filtration at high pressure difference. Other filtration rates, which are not mentioned in this brochure, can be obtained on request.

	Mainly used filter material: Interpr Fleece "VG" Glass Fibre . deep filtration . high particle-holding capacity . best micron rating at high p . usable for water glycol, phosphate ester fluids . available 1 µm, 3 µm, 6 µm, 10 µm, 16 µm and 25 µm.			VG - Glass Fibre
	Paper Matting "P" . deep filtration . paper matting consists of paper and polyester fibre . higher material stability and strength . low swelling reaction . available in 10 µm and 25 µm			Stainless Steel Mesh 'G'
	Stainless Steel Mesh "G" . surface holding filtration . stainless steel wire mesh can be used on corrosive liquids . difficult to clean . available 25 µm, 40 µm and 80 µm, other µm rating on request.			Paper Matting 'P'
	International Standards manufacturing and quality control. In addition to tests developed by INTERNORMEN -FILTER, testing to the following ISO-Standards is done: ISO 2941 Verification of collapse/burst resistance ISO 2942 Verification of fabrication integrity ISO 2943 Verification of material compatibility with fluids. ISO 3723 Method for end load testing. ISO 3724 Verification of flow fatigue characteristics ISO 3968 Evaluation of pressure drop versus flow characteristics ISO 4572 Multi-Pass methods for evaluating filtration performance.